Camera battery charging installation method

The camera should not only pay attention to maintenance, but also pay attention to the maintenance of the power supply, that is, the battery. If the camera battery fails to maintain properly, it may burn the machine or cause an explosion, so we need to take good care of our battery.

When the camera battery is to be charged, it is best to use the original charger for charging. At the same time, make sure that our machine is turned off before charging the camera battery. After all, an unqualified charger will damage the battery, causing the battery to easily fail or age. If you need to replace the battery when shooting, we must remember to shut down and replace it. Hold down the snap button above the battery cover of the camera with one hand and don't move it. Use the other hand to buckle up the battery to buckle it.

Take off the battery, such as the new camera battery, you should use the charger to charge in time. The battery will continue to charge for 6 hours after the charging lamp is off. Both nickel-cadmium batteries and nickel-metal hydride batteries have a memory effect. When the charger is charging, it will continue to charge for 40 minutes when it shows 90%. It can be said that there is a self-discharge phenomenon every time it is charged. The battery must be fully discharged before charging, otherwise it will reduce the capacity of the battery.

Therefore, the battery in long-term storage should be charged when it is in an environment and a state of moderate temperature, and it is best to charge and discharge it every 3 months. Do not charge at high and low temperatures, prevent falling during use, and do not put it in a humid environment. This will also be detrimental to the battery and reduce the service life. At the same time, the camera battery should be placed normally to avoid damage to the battery. Internal short circuit. Note that when the camera battery is full and ready to be installed, put the battery into the battery box with the data port facing down, and gently press down with your fingers. It will be installed successfully, start the test and see if the installation is successful!